
⚠ New product:
available in the second semester 2020
available in the second semester 2020
TITANIUM3-S
remote control to command up to 3 motors individually + all of them in a group; sun sensor exclusion
special remote control to be used with awnings which works with SW4 (sun-wind sensor)
- Remote control TITAMIUM3-S is used to manage up to 3 motors individually moreover all of them grouped together, installed in solar protection systems
- It has a button dedicated to the activation (sun on) or deactivation (sun off) the commands forwards by sun sensor (SW4). When it is in Sun Off, all the 3 awnings on this remote won't attend the commands from usn sensor
- It has 2 LEDs on the front, which are showing if the solar sensor is activated or not (when we activate/deactivate, the motor confirms with a small movement of the awning)
- TITANIUM3-S has a simple and intuitive operation mode. It has 6 buttons, divided in 2 sides to command easily the awning or other sun protection system:
- Right side has 3 command buttons for stadard use (⬆ Open, ⏹ Stop and ⬇ Closed)
- Left side, has 3 buttons which is automatic way, are providing 3 intermediate points (only for radio motors)
- ⏹ Stop button, allows also to set an user preferred point
- Channel selecting button which are shows in 3 leds, to do it easier for user

What does the TITANIUM3-S (emsteel1s) offer if it is installed together with the JE50R4AW and SW4?

Fully automatic operation, interaction with the wind:

- The sun sensor (once the brightness range is exceeded) send a command to extend the awning
- While the awning is open, a gust of air causes the awning to retract
- After 10 minutes without air and if brightness is above the programmed level, the awning is extended again
- When night falls, when the brightness falls below the programmed the awning is collected
- A next day, after the brightness exceeds the set, the awning is extended
- ...
Fully automatic operation, interaction with low brightness:
Automatic operation with user interruption:
Operation after having disabled and enabled the sun (EMSTEEL1S):
Remote control with multiple intermediate points:
Remote control TITANIUM1 is capable of managing up to 6 end points on enjoy R4 radio motors (in those motors with these 6 stop points): upper limit switch, 3 intermediate positions (automatically created), as well as a fourth preferred user position that can be easily created from the remote control and the lower limit switch
Operating type:
Individual operating mode (3 channels with 3 awnings):
Group operation mode (it has a channel supplementary to command these 3 awnings in a group)
Next diagram is showing an standard use of TITANIUM3-S:
What products can I use it with?
- Remote control TITANIUM3-S, is compatible with all enjoy R4 radio motors for awnigs and these openes which can works with device SW4 (JE50R4AW, JE50R4AWL, JE50R4ZIP, JE50R4RH)
- Enjoy R4 works with frequency 433.92 MHz and has the rolling code system to protect the signal
Packed with the product:
- x1 TITATIUM3-S remote control
- x1 programming stick
- x1 wall bracket
- x1 screw cover
- x2 plug and screw for fixing bracket
- x1 use and programming manual
- x1 courtesy CR2450 battery (replace when necessary)