
EMSTEEL1S
remote control to command 1 motor individually or a group; with sun sensor exclusion
special remote control to be used with awnings which works with SW4 (sun-wind sensor)
- Remote control EMSTEEL1S is used to manage up to 3 motors individually moreover all of them grouped together, installed in solar protection systems
- It has a button dedicated to the activation (sun on) or deactivation (sun off) the commands forwards by sun sensor (SW4). When it is in Sun Off, all the 3 awnings on this remote won't attend the commands from usn sensor
- It has 2 LEDs on the front, which are showing if the solar sensor is activated or not (when we activate/deactivate, the motor confirms with a small movement of the awning)
- EMSTEEL1S has a simple and intuitive operation mode. Its 3 command buttons allow users open, closed or stops the awning or solar protection system
- Stop button, allows also to set an user preferred point

What does the EMSTEEL1-S offer if it is installed together with the JE50R4AW and SW4?

Fully automatic operation, interaction with the wind:

- The sun sensor (once the brightness range is exceeded) send a command to extend the awning
- While the awning is open, a gust of air causes the awning to retract
- After 10 minutes without air and if brightness is above the programmed level, the awning is extended again
- When night falls, when the brightness falls below the programmed the awning is collected
- A next day, after the brightness exceeds the set, the awning is extended
- ...
Fully automatic operation, interaction with low brightness:
Automatic operation with user interruption:
Operation after having disabled and enabled the sun (EMSTEEL1S):
Operating type:
Individual operating mode (1 channel for 1 awning):

Group operation mode (1 channel for 4 awnigs):


Group operation mode (1 channel for 4 awnigs):

What products can I use it with?
- Remote control EMSTEEL1S, is compatible with all enjoy R4 radio motors for awnigs and these openes which can works with device SW4 (JE50R4AW, JE50R4AWL, JE50R4ZIP, JE50R4RH)
- Enjoy R4 works with frequency 433.92 MHz and has the rolling code system to protect the signal
Packed with the product:
- x1 EMSTEEL1S remote control
- x1 programming stick
- x1 wall bracket
- x1 screw cover
- x1 plug and screw for fixing bracket
- x1 use and programming manual
- x1 courtesy CR2032 battery (replace when necessary)