
RECMAD01
receiver to placed in the roller shutter box
receiver enjoy R4 to be used with mechanical or electronic limit switch motors
Receiver with 433.92 MHz frequency, for managing a mechanical motor or an electronic motor wirelessly. Compatible with all other enjoy R4 products
- To be used with motors up to 400 W
- Programming the first remote control when receiver is powered. All the other remotes can be memorized without the need to manipulate the receiver or power
- RECMAD01 admits up to 15 remotes controls
- An external wired push-button (1 key) is available
- Internal connection strip, to facilitate motor and power wiring in
- Step by step function (tilting) can be enable/disable from remote control

Operating type:
Individual operating mode (1 receiver for 1 roller shutter): besides it admits an external wiring push-button (1 key) to command the motor without the remote control
Attention:
- It is not allow to connect more than 1 mechanical motor directly to the receiver RECMAD01
- If you want to convert several mechanical motors into radio products, you must use a receiver for each motor
- In the case of ELM motors, if they are going to work as a group, several motors can be connected into the receiver, with the limit that the sum of the watts (W) of these motors does not exceed 400w
Wiring options:
Technical data:
Product Code | RECMAD01 |
Input power | 230V-50Hz |
Output power | 230V-50Hz |
Watts capacity | 400W |
Protection rating | IP54 |
Product Dimensions | 110 x 35 x 24 mm |
What products can I use it with?:
- Receiver RECMAD01, is compatible with all mechanical and electronic motors from our series JE40 and JE50 (up to 400W)
- Receiver RECMAD01 is compatible with all enjoy R4 remotes controls: Titamium, Steel, Murus, ...The buttons on the left side present in some of these remote controls will not activate with the receiver RECMAD01
- Enjoy R4 works with frequency 433.92 MHz and has the rolling code system to protect the signal