• Motor JE50/20FCM12V with 20Nm and 12 RPM. 
• End limits (upper and lower points) are made in the traditional way by the standard two screws located on the motor head.
• Being a low voltage motor, it is suitable for rooms where the motor cannot be in its standard AC230V current format.
• It can be powered by a DC12V transformer or battery, connected to a 6-way shutter switch or specific systems for this purpose.

 Main Features:

Motor JE50FCM has the traditional limits setting. On the motor head there are 2 screws that are corresponding with the motor movement, represented by an arrow. It is very important to understand that said arrow does not indicate if the roller shutter is going uo or down, if you see the arrow or down, but rather indicates the rotation of the motor and therefore the movement that the shutter will perform.
in the example:

• the upper screw represented by the arrow  ⬇ (green color) corresponds to the upper limit (because turning in that sense the blind is rolled up). For setting, we will turn the upper screw in the + direction if roller shutter has to rise more than it stops automatically or in the opposite way if it has to stop at a lower point
• the lower screw represented by the arrow ⬆ (red color) corresponds to the lower limit (because turning in that sense the blind is unrolling). For setting, we will turn the lower screw in the + direction if has to downwards more  than its stops automatically or in the opposite way if it has to stop at a higher point