• Tubular motor for large roll-up doors, which startinng from a 100mm axis and require high lifting capacity (without the help of springs)
• End limits (upper and lower points) are made through 2 wheels or regulation gears located on the motor head
• Motor with 4-wire cable: Neutral (blue) and two wires corresponding to the direction of rotation (black and brown), in addition to the ground. To connect to a fixed switch or other external systems such as receivers, centralization modules or home automation devices
• It is recommended to use it in conjunction with an “safety brake” AS0946, to guarantee the blocking of the rolling door, in the event that the engine brake suffers a breakdown, and thus avoiding free unrolling of the door
• Possibility to operate the motor, even in the absence of electricity, through a hand crank, thus providing the security that, if necessary, we can raise or lower the roller shutters

Main features:

• the orange wheel corresponds to the upward direction of rotation (the roller shutter is rolled up) and although the arrow is down ⬇, it really corresponds to the movement of the shutter's goes up. For setting we will turn the orange wheel in the + direction if roller shutter has to rise more than it stops automatically or in the opposite way if it has to stop at a lower point
• the green wheel corresponds to the direction of rotation down (the roller shutter is unrolling) and although the arrow is up ⬆ it really corresponds to the movement of the shutter's goes down. For setting we will turn the green wheel in the + direction if has to downwards more  than its stops automatically or in the opposite way if it has to stop at a higher point

• Transmitter unit. It receives the order by the rubber detector of the 2-wire terminal, and sends the stop order to the RECMAD03 receiver via radio under the freq. 433.92MHz
• Detector rubber for terminal
• Magnetic connector to deactivate the sensor when it reaches the lower point